02.04.2010, 16:09
(Dieser Beitrag wurde zuletzt bearbeitet: 02.04.2010, 16:16 von Broadcasttechniker.)
This is strange, because i only know the opposite effect.
If there is a fault with the speed sensor (the one plugged into the gearbox), the speedo shows "0"kmh, and the steering works insensitive, it's too smooth.
There might be a problem with the "motor-is-running" signal.
As far as i know, its not a static signal, but it is derived from the top-dead-centre sensor signal.
It should be the same signal that is used for the rev counter coming out of the ECU.
Please download the english manual
http://www.megaupload.com/?d=B7KIEY3B
and this is the password, characters are lower case.
http://www.twingotuningforum.de/attachment.php?aid=1848
Sinngemäß
Er hat wohl doch noch Probs mit dem "Motor läuft" Signal.
Mein Tip, man sollte das Drehzahlmesersignal aus dem Einspritzsteuergerät nehmen.
Das haben die bisher erfolgreichen Umbauer auch so gemacht.
Da dieser Pin bei jedem Steuergerät anders ist, bitte in der Doku nachschauen.
If there is a fault with the speed sensor (the one plugged into the gearbox), the speedo shows "0"kmh, and the steering works insensitive, it's too smooth.
There might be a problem with the "motor-is-running" signal.
As far as i know, its not a static signal, but it is derived from the top-dead-centre sensor signal.
It should be the same signal that is used for the rev counter coming out of the ECU.
Please download the english manual
http://www.megaupload.com/?d=B7KIEY3B
and this is the password, characters are lower case.
http://www.twingotuningforum.de/attachment.php?aid=1848
Sinngemäß
Er hat wohl doch noch Probs mit dem "Motor läuft" Signal.
Mein Tip, man sollte das Drehzahlmesersignal aus dem Einspritzsteuergerät nehmen.
Das haben die bisher erfolgreichen Umbauer auch so gemacht.
Da dieser Pin bei jedem Steuergerät anders ist, bitte in der Doku nachschauen.
Geteiltes Wissen ist doppeltes Wissen