11.09.2018, 19:03
New distributor arm new distributor ?
Check all connections , control device, ground cable, Map-Sensor, Lambda .....
Compression is 11 bar. Valve clearance checked, outlet 0,2 mm, inlet 0,15 mm?
Firing order is 1-3-4-2.
Switch on ignition, then wait 60 seconds before starting.
Another way is to push gas pedal down for a very short time while cranking the engine.
Always check for wet plugs. Tubes all clean and connected,
Map sensor tube also very important.
Check all connections , control device, ground cable, Map-Sensor, Lambda .....
Compression is 11 bar. Valve clearance checked, outlet 0,2 mm, inlet 0,15 mm?
Firing order is 1-3-4-2.
Switch on ignition, then wait 60 seconds before starting.
Another way is to push gas pedal down for a very short time while cranking the engine.
Always check for wet plugs. Tubes all clean and connected,
Map sensor tube also very important.