07.06.2020, 15:13
Hi. The clip gives me this error with my c3g engine.
I have tested the resistance as the manual says of the solenoid and it's 35 ohm as it should. Solenoid was tested with a vacuum pump and 12 volt voltage and it seems to work. Checked the cable output. It gives 12 v on one pin and I had a continunity between the other one and the 22 pin of the computer connector. What else can be wrong.
Also it seems like the clip only connects to the computer properly when engine is off, anyone knows how to fix any of these 2 problems? It's the rtl2002 clone with the expensive chips.
I have tested the resistance as the manual says of the solenoid and it's 35 ohm as it should. Solenoid was tested with a vacuum pump and 12 volt voltage and it seems to work. Checked the cable output. It gives 12 v on one pin and I had a continunity between the other one and the 22 pin of the computer connector. What else can be wrong.
Also it seems like the clip only connects to the computer properly when engine is off, anyone knows how to fix any of these 2 problems? It's the rtl2002 clone with the expensive chips.