20.09.2018, 10:15
(Dieser Beitrag wurde zuletzt bearbeitet: 20.09.2018, 10:16 von Broadcasttechniker.)
You only have to remove the big ends of the cylinders in question.
In my case I had to remove them all because i didn't know how thin or thick the old gaskets were.
Besides.
If there is no water in the oilsump, the O-rings will be o.K.
So dont do anything that is unnecessary
With the R4 of my sister there were no compression problems but water in the oil.
In my case I had to remove them all because i didn't know how thin or thick the old gaskets were.
Besides.
If there is no water in the oilsump, the O-rings will be o.K.
So dont do anything that is unnecessary
With the R4 of my sister there were no compression problems but water in the oil.
Geteiltes Wissen ist doppeltes Wissen