19.10.2011, 16:10
wegen der haube: bei uns wurde die verstrebung in der mitte entfernt... ist natürlich alles dann ermessenssache des prüfers, da er dir die nachher ja auch abnehmen soll. im endeffekt ist unsere haube aber nun durch die hutze und das doppelte blech (bei den schweißstellen) meiner meinung nach sehr stabil.
habe es aber natürlich nicht im extremstfall getestet
hier mal ein bild vom innenleben:
![[Bild: twingo-19150542-H1X.jpg]](https://pics.twingotuningforum.de/pics/2011/10/twingo-19150542-H1X.jpg)
von außen schaut das ganze etwa nun so aus:
![[Bild: twingo-19150912-SBW.jpg]](https://pics.twingotuningforum.de/pics/2011/10/twingo-19150912-SBW.jpg)
habe es aber natürlich nicht im extremstfall getestet

hier mal ein bild vom innenleben:
![[Bild: twingo-19150542-H1X.jpg]](https://pics.twingotuningforum.de/pics/2011/10/twingo-19150542-H1X.jpg)
von außen schaut das ganze etwa nun so aus:
![[Bild: twingo-19150912-SBW.jpg]](https://pics.twingotuningforum.de/pics/2011/10/twingo-19150912-SBW.jpg)
![[Bild: twingo-19151006-OhD.jpg]](https://pics.twingotuningforum.de/pics/2011/10/twingo-19151006-OhD.jpg)