Any ideas how to fix a broken fuel pump nipple? - Druckversion +- Das Twingoforum... (https://www.twingotuningforum.de) +-- Forum: Werkstatt (https://www.twingotuningforum.de/forum-31.html) +--- Forum: Motor (https://www.twingotuningforum.de/forum-55.html) +--- Thema: Any ideas how to fix a broken fuel pump nipple? (/thread-41055.html) |
Any ideas how to fix a broken fuel pump nipple? - ronenfe - 21.09.2019 I tried epoxy but it started to leak after a while. Also what is the difference between the o rings and the plastic nuts in this diagram? What does it mean (i) -> 970701 (q) 970701 -> M0D9809 (g) M0D9809 -> Mine is c3g 1995. RE: Any ideas how to fix a broken fuel pump nipple? - OHC TUNER - 21.09.2019 You can't fix it , the best Option is a new Pump . The O-Ring works only in the right Position , is a little complicate to find it . RE: Any ideas how to fix a broken fuel pump nipple? - Broadcasttechniker - 21.09.2019 Espace Freunde Forum has problems with their pictures. Here ist how someone has done it. Don't! https://www.google.de/search?hl=de&biw=1920&bih=881&tbm=isch&sa=1&ei=AlKGXdCDLc7TwALtoLqQDQ&q=espace+freunde+benzinpumpe+h%C3%BClse&oq=espace+freunde+benzinpumpe+h%C3%BClse&gs_l=img.3...20099.21775..21981...0.0..0.203.438.4j0j1......0....1..gws-wiz-img.4KI5gLHmIek&ved=0ahUKEwjQjImHreLkAhXOKVAKHW2QDtIQ4dUDCAY&uact=5 The Espace is worse than the twingo because there is always stress on the fuel line. RE: Any ideas how to fix a broken fuel pump nipple? - ronenfe - 25.12.2019 I replaced The whole upper plastic in the pump with a used one I removed from a used pump I got on Ebay. RE: Any ideas how to fix a broken fuel pump nipple? - ronenfe - 26.03.2020 How do I keep the pump in place so the arrow stays where it should be when I'm rotating the plastic nut? It turns with it and I can't hold it. Also I'm using the plastic nut with the o ring which I'm not sure is the right one for my car, my old plastic nut was broken and didn't have an o ring. I had a leak from the nut when filling the tank from more than half. Now I have a tool for screwing it but I don't know how much I should screw it, manual says max 60nm. Anyway I can't hold the pump in place. RE: Any ideas how to fix a broken fuel pump nipple? - Broadcasttechniker - 26.03.2020 Isn't there a notch? If not, I don't know. RE: Any ideas how to fix a broken fuel pump nipple? - ronenfe - 28.03.2020 There isn't a notch on the early models. What I found out is that the o ring shouldn't be used on these models. This what caused the pump to turn with the nut. Without it, it went perfect. Also I found out I have a 2A fuse with a gear shift drawing, that if I take it out, the starter will not work. Also when you turn the key to ignition, the voltage to the fuel pump , 12v will only be on for about 1 second, then it will shut down I got the nut tighten to about 40nm. RE: Any ideas how to fix a broken fuel pump nipple? - Broadcasttechniker - 28.03.2020 The 2A fuse belongs to the Quickshift(relay). The fuel pump will only work for a second on power on self test. Thats normal, even with the latest models. And of course, if there a pulses from the flywheelsensor. |